ThePipingMart Blog Metals How to Remove Protective Film from Stainless Steel?

How to Remove Protective Film from Stainless Steel?

How to Remove Protective Film from Stainless Steel

If you’ve ever purchased a stainless steel appliance, you may have noticed that the surface often comes covered with a protective film. This film is designed to protect the stainless steel from scratches and other damage during shipping and installation. But once your appliances are in place, it’s time to remove this film—which can be easier said than done. So, how do you get rid of those pesky layers of plastic without damaging your shiny new appliances? Read on to find out!

The first step is to make sure you have all the right tools handy. You’ll need a cloth or sponge, dish soap, warm water, and a scraping tool such as a razor blade or putty knife. Once all these supplies are gathered together, it’s time to begin removing the protective film from your stainless steel appliance.

Start by dampening the cloth or sponge with warm water and some dish soap. Then use this soapy cloth to wipe away any dirt or dust from the stainless steel surface. Doing this will help prevent scratches while you’re scraping off the protective film.

Next, use a razor blade or putty knife to begin gently prying up one corner of the protective film. Be sure not to press too hard, as this could cause damage to both the film and the stainless steel below it. Once you’ve got one corner lifted up, start slowly peeling back the rest of the film until it’s fully removed from the appliance’s surface.

As an alternative method, some people find success using mineral oil or laundry detergent mixed with warm water instead of dish soap and water for scrubbing off their protective films. Whichever solution works best for you is fine—just make sure that whatever cleaning product you choose is safe for stainless steel before applying it directly onto your appliance!


Removing protective films from stainless steel surfaces doesn’t have to be difficult—all it takes is a little patience and some know-how! Start by gathering your supplies—a cloth or sponge, dish soap (or mineral oil/laundry detergent), warm water, and a scraping tool like a razor blade or putty knife—and then dampen your soapy cloth with warm water before wiping down any dirt or dust on your appliance’s surface. Next, use either your razor blade or putty knife to lift up one corner of the plastic film before slowly peeling back its entirety until it’s gone completely from the appliance’s surface! With these steps in mind, you should have no problem removing that pesky plastic layer in no time at all! Good luck!

Related Post